When configuring your network, ensure that there is no ‘back door’ access to the protected network. For example, if there is a wireless access point, it must be appropriately protected with password and encryption.
Be sure to also maintain an up-to-date network diagram which includes IP addressing, cabling, and network elements.
- Always configure a default route.
- Add blackhole routes for subnets reachable using VPN tunnels. This ensures that if a VPN tunnel goes down, traffic is not mistakingly routed to the Internet unencrypted.
Keep the number of policy routes to a minimum to optimize performance in route lookup and to simplify troubleshooting.
- Select a Router ID that matches an IP assigned to an interface. This avoids the likelihood of having two devices with the same router ID.
- For routing over an IPsec tunnel, assign IP addresses to both ends of the tunnel.
Use the following best practices for advanced routing when dealing with Border Gateway Protocol (BGP) and Open Shortest Path First (OSPF).
Border Gateway Protocol (BGP)
If you are using BGP, it is recommended that you enable soft-reconfiguration. This has two benefits:
- It allows you to perform ‘soft clear’ of peers after a change is made to a BGP policy.
- It provides greater visibility into the specific prefixes learned from each neighbor.
Leave soft-reconfiguration disabled if your FortiGate does not have much unused memory. Soft-reconfiguration requires keeping separate copies of prefixes received and advertised, in addition to the local BGP database.
Open Shortest Path First (OSPF)
- Avoid use of passive interfaces wherever possible.
- Avoid use of virtual links to connect areas. All areas should be designed to connect directly to the backbone area.
- Ensure that all backbone routers have a minimum of two peering connections to other backbone neighbors.
- An entire OSPF domain should be under common administration.
Network Address Translation (NAT)
- Beware of misconfiguring the IP Pool range. Double-check the start and end IPs of each IP pool. The IP pool should not overlap with addresses assigned to FortiGate interfaces or to any hosts on directly connected networks.
- If you have internal and external users accessing the same servers, use split DNS to offer an internal IP to internal users so that they don’t have to use the external-facing VIP.
Do not enable NAT for inbound traffic unless it is required by an application. If, for example, NAT is enabled for inbound SMTP traffic, the SMTP server might act as an open relay.
- Do not connect two ports to the same VLAN on a switch or to the same hub. Some Layer 2 switches become unstable when they detect the same MAC address originating on more than one switch interface or from more than one VLAN.
- If you operate multiple VLANs on your FortiGate unit, assign each VLAN id to its own forwarding domain to ensure that the scope of the broadcast does not extend beyond the VLAN it originated in.
To protect against Layer 2 loops:
- Enable stpforward on all interfaces.
- Use separate VDOMs for production traffic (TP mode VDOM) and management traffic (NAT/Route mode VDOM).
- Only place those interfaces used for production in the TP mode VDOM. Place all other interfaces in the NAT/Route mode VDOM. This protects against potential Layer 2 loops.
Using Virtual IPs (VIPs)
- Use the external IP of 0.0.0.0 when creating a VIP for a FortiGate unit where the external interface IP address is dynamically assigned.
- Be sure to select the correct external interface when creating a new virtual IP (VIP). The external interface should be set to the interface at which the FortiGate unit receives connection requests from external networks.
Having trouble configuring your Fortinet hardware or have some questions you need answered? Check Out The Fortinet Guru Youtube Channel! Want someone else to deal with it for you? Get some consulting from Fortinet GURU!