Probing interfaces

Probing interfaces

Server probes can be used on interfaces. In order for this to occur, the probe response mode must first be configured, then the probe response must be allowed administrative access on the interface. The probe response mode can be:

none                    Disable probe.

http-probe             HTTP probe.

twamp                   Two way active measurement protocol. Both steps must be done through the CLI.

Configuring the probe

config system probe-response set mode http-probe

end

 

Allowing the probe response to have administrative access to the interface

config system interface edit <port>

set allowaccess probe-response end

This entry was posted in FortiGate, FortiOS, FortiOS 5.4 Handbook and tagged , on by .

About Mike

Michael Pruett, CISSP has a wide range of cyber-security and network engineering expertise. The plethora of vendors that resell hardware but have zero engineering knowledge resulting in the wrong hardware or configuration being deployed is a major pet peeve of Michael's. This site was started in an effort to spread information while providing the option of quality consulting services at a much lower price than Fortinet Professional Services. Owns PacketLlama.Com (Fortinet Hardware Sales) and Office Of The CISO, LLC (Cybersecurity consulting firm).

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.