Configuring FortiWLM Location Manager
Location Manager is supported by release 3.7 and later.
Configuring with the CLI
This example creates a packet-capture-profile named Location on a controller and then forwards the captured packets directly from AP 16 to Location Manager on port #9177. Port 9177 is the port where Location Manager is listening for incoming packets in L3 mode.
MC3K‐1#
MC3K‐1# configure terminal
Licensing for Virtual Controllers
MC3K‐1(config)# packet‐capture‐profile Location
MC3K‐1(config‐pcap)# mode l3 destination‐ip 1.1.1.1 port 9177
MC3K‐1(config‐pcap)# ap‐list 16
MC3K‐1(config‐pcap)# exit
MC3K‐1(config)# exit
MC3K‐1# show packet‐capture‐profile Location AP Packet Capture profiles
Packet Capture Profile Name : Location Packet Capture profile Enable/Disable : off
Modes Allowed L2/L3 : l3
Destination IP Address : 1.1.1.1
UDP Destination Port : 9177
Destination MAC for L2 mode : 00:00:00:00:00:00
Rx only/Tx only/Both : rx
Rate Limiting per station or cumulative : station
Token Bucket Rate : 10 Token Bucket Size : 10 AP Selection : 16
Extended Filter String : Interface List :
Packet Truncation Length : 82
Rate Limiting : off
Capture frames sent by other APs in the network : on MC3K‐1#
For a detailed explanation of the packet capture profile commands, see the Troubleshooting chapter of the FortiWLC (SD) Configuration Guide.
Having trouble configuring your Fortinet hardware or have some questions you need answered? Check Out The Fortinet Guru Youtube Channel! Want someone else to deal with it for you? Get some consulting from Fortinet GURU!