Using the Rogue AP Monitor
Go to Monitor > Rogue AP Monitor to view the list of other wireless access points that are receivable at your location.
Information Columns
Actual columns displayed depends on Column Settings. |
Rogue AP — Use this status for unauthorized APs that On-wire status indicates are attached to your wired networks.
Accepted AP — Use this status for APs that are an authorized part of your network or Stateare neighboring APs that are not a security threat. To see accepted APs in the list, select Show Accepted. Unclassified — This is the initial status of a discovered AP. You can change an AP back to unclassified if you have mistakenly marked it as Rogue or Accepted. |
OnlineActive AP
Status Inactive AP Active ad-hoc WiFi device Inactive ad-hoc WiFi device |
SSID The wireless service set identifier (SSID) or network name for the wireless interface. |
Security The type of security currently being used. Type |
Channel The wireless radio channel that the access point uses. |
MAC The MAC address of the Wireless interface. Address |
Vendor
The name of the vendor. Info |
Signal The relative signal strength of the AP. Mouse over the symbol to view the signal-to-noise Strength ratio. |
Detected
The name or serial number of the AP unit that detected the signal. By |
On-wire A green up-arrow indicates a suspected rogue, based on the on-wire detection technique. A red down-arrow indicates AP is not a suspected rogue. |
First Seen How long ago this AP was first detected. |
Suppressing
Last Seen | How long ago this AP was last detected. |
Rate | Data rate in bps. |
To change the Online Status of an AP, right-click it and select Mark Accepted or Mark Rogue.
Having trouble configuring your Fortinet hardware or have some questions you need answered? Check Out The Fortinet Guru Youtube Channel! Want someone else to deal with it for you? Get some consulting from Fortinet GURU!